1. Forum
  2. Newsgroups
  3. comp.sys.ibm.ps2.hardware

  • HP ScanJet 6100c lashed back together...

    From Louis Ohland@ohland@charter.net to comp.sys.ibm.ps2.hardware on Fri Jul 11 12:53:31 2025
    From Newsgroup: comp.sys.ibm.ps2.hardware

    Both front mounting posts twisted off right where they met the
    horizontal frame and the JB PlasticWeld squeezed a little into the space between the parts. WD40 Specialist Dry Lube did a good job of keeping
    the torque needed to screw in the screws to a reasonable level...

    Got back from Ace Hardware, used .125" thick nylon washers [Hillman] to
    space the front frame screws' captive metal washer. Used two nylon
    washers, a smaller OD nestled inside a larger ID to fill the entire area
    under the captive metal washer.

    Seems to be a firm fit.

    --- Synchronet 3.21a-Linux NewsLink 1.2